Page 1 of 1

Looking into a 3d printed Behemoth

Posted: Wed Oct 16, 2013 2:17 pm
by azironlegion
I'm strongly considering getting a 3D printed Behemoth (because the current sculpt is horrid) and the Extremoth just doesnt do it for me. I want to get a model that more closely resembles the artwork. Is anyone good at or know someone good with 3D modeling? Im ok (Maya) but not the best and want to try and maybe collaborate on it. I remember seeing on a forum someone did it for Typhon from LoE and it looks AMAZEBALLS. Im aware of the tourney legalities but considering ive been in 1 tournament in the past 8 years i dont think it will bother me much.

Re: Looking into a 3d printed Behemoth

Posted: Wed Oct 23, 2013 2:57 pm
by theHman
I'm surprised you'd go the 3D printed route.
I would have expected doing a conversion to be much better.
If you do finally get one done, I would love to see pics of it.

Re: Looking into a 3d printed Behemoth

Posted: Wed Oct 23, 2013 7:13 pm
by azironlegion
At first I was going to suck it up and make an extremoth but even that looks off to me. I want something more true to the artwork.

Re: Looking into a 3d printed Behemoth

Posted: Fri Nov 08, 2013 11:29 am
by Ninja Goblin
I know several artists capable of creating what you are looking for but before you move forward understand that the cost is substantial (a few hundred dollars) to have it designed... and high resolution printers (the ones good enough to make your mini look nice) are very expensive and so they charge a premium for one offs.

If you are still interested I can help shoot me a pm.